Lay sewer pipes, crushed from plastic, it is easier to make it easier, lower the water supply from the same plastic. The old chavun trumpets have long since rusted and began to clog up, what did the thoughts about this replacement call out to? It is necessary for us to change the number of parameters:
- Number of sticks (fewer sticks, then more).
- Number of turns (some less, more better).
- Glybina sewerage pits.
In order for the sewerage system to function correctly, it is necessary to observe the following rules:
2). Tse to fight in order to escape the trap.
3) Do not shorten or cut shaped parts.
4) Don't beat the beaten chi poshkodzhenі trumpet chi completing before them.
5) Carefully look at the pockets of damages for defects.
6) Transfer the sewer pipe to 1 meter.
Installation rules
Normal operation of the sewerage system is impossible without proper fixing of these elements. It's a pity that plastic pipes are succumbing to such a phenomenon, like deforming, so badly fastened details under the ground to prosіdatimut and change the cut of the stack. The sewerage was cut off by 1 meter at the degrees of rozrakhovuєtsya for the help of clear ventilation during the planting of pipes. Also sporudzhuyut spetsіlnі krіplennya over pipes croque 70 centimeters. The maximum loss of pipes is 15%, and the higher degree of non-recommendations through the replacement parts. 
Freeze the sewers for 1 meter, you need it, repairing it as soon as possible and ending with a wicked pit. Obov'yazkovo slid the whole story to the presence of the same evidence of the sleaze.
Roofing pipes diameter
The value of the diameter of the sewer pipe should be laid down according to the number of units of plumbing connected to the system, and to name the value, as if the sewerage had lost 1 meter. Professionals induce formulas, zgіdno z yakimi rozrakhovuyut singing diameter. Vіn fallow due to such factors, like:
- Number of turns.
- I lost my breath.
- Number of sticks.
- Number of plumbers.
Formulas to stop ringing every hour of laying a sewerage system at great enterprises, and private houses or apartments for whom there is no need.
The riser and pipes, which are connected to the sewerage pits, can be 100 mm in diameter. But if, for example, the pipe has a diameter of 150 millimeters, then the riser is guilty of this value. It is also important to note that in order to connect the toilet bowl to the pouring system, it is necessary to turn the pipes with a diameter of 100 mm.
The drain of the sewerage (by 1 meter) near the apartment is to be 4-5 centimeters from the cob and to її kintsya, to ensure the flow rate of 0.7 m / s, the diameter of the pipe is to be increased to 80 mm.
Fan ventilation at the sewerage extension
Fan ventilation - the whole pipe, installed in the dachas and taken out of the sewerage system. Vaughn serve to stabilize the pressure of the wind in the system. With sharp fluctuations in the pressure of fan ventilation, the best solutions.
Fall under the pressure of viscous the motherland from the siphons and other places from the water blockage, thereby giving access to the place of the unacceptable smell.
In richly-topped booths, the central sewer pipe is not weak and is installed vertically, there are a large number of shards in it.
When rozrahunku such factors, like a sewer pipe 100 per 1 meter and the volume of sewage, sound like a pipe diameter. After the calculation of these values, it is discussed what to install: a fan system (for large connections) or a gate valve (for small connections).
Pratsyuє less in one straight, and itself - at the pass again less in one bіk. An ideal option for small pressures at pipes - when it is closed, the valve opens and tightens again at the pipe.
Cleaning of sewerage systems
Cleaning - all the details installed at the turn of the pipe. They also stood in Radyansk chavunny systems for cleaning from blockages. Qiu system was introduced and in - easy, handy and practical. All the same, they looked at her like a god, shards richly hto vvazhav, scho such an attachment unaesthetically looking at the infamous aphids.
Please! Stolen sewerage by 1 meter - both external and internal - are repaid however. The trenches for laying the pipes are of the same line, but they are even, so that when the soil swells up, there will be no bending or cracks.
Also, when installing inspection hatches (revisions). Vіdstan m_zh them dorivnyuє 13-16 meters. In rich-topped budinkas, such hatches were installed on top of leather chotiri.
Installation of plastic to the chavunny sewerage system
For those who cannot afford to change the entire sewerage system, they will change only the problematic parts. І at which stage they stick from the arrival of plastic pipes to the old chavunny ones.
If you are a sack of a bagat-top-covered booth, then do not forget to re-convert all the susіdіv іlka іlka not vikoristovuvatiu kanіlаіzаіu, schob unacceptable momentіv pіd hour installation. For the arrival of such pipes, it is necessary to vicorize fittings prepared specifically for these purposes.
Important! With the central chavun pipe and plastic pipe connected, as if coming from the apartment, it is not guilty to reach 90 degrees.
Options for stitching:
1).
2) Three views of 30 degrees each are victorious.
3) Vykoristovuyutsya chotiri vіdvedennya 22 degrees.
In case of any option, the sewage system has lost 1 meter, it is the responsibility of the insurance to be paid individually. As soon as the system is installed in a private booth, such wiring is not needed, if only a larger diameter of the sewer pipe is required.
Pardons for the installation of the sewerage system
Too many pardons are allowed during installation, and the system is often clogged or not functioning. The most common pardons:
1).
2) Incorrect sewer drain by 1 meter.
3) The presence of marks on the pipes after sawing.
1) Laying of plastic pipes is carried out in the ground, on which do not add additives of interest (moving for cars).
3) Humki are respectfully chosen to strengthen, shards of stench vibrate around the sewer pipes and may not fit or sit slightly.
4) To join the pipes, follow the vikoristovuvati oil (shampoo, miyuchy, cute). Tse suttevo to make the job easier. 
5) For the normal functioning of the system, the intake gap is recommended: for pipes 50 mm - 0.36 cm, and for 100 mm - 0.47 cm.
6) To connect a plumbing fixture for an additional flexible hose, it is necessary to use special cuffs for strengthening. The diameter of the inlet opening can be matched to the diameter of the pipe.